Strain- and Bridge-Based USB Measurement Modules


Force and pressure transducers, load cells, torque sensors and even accelerometers often use bridge-based measurement circuits. Our measurement devices enable direct connection of all full-bridge, half-bridge, and quarter-bridge sensors, providing internal bridge excitation. DT9838 supports TEDS.

DT9838

DT9829 Series

QuickDAQ FFT Analysis

4-Channel USB Data Acquisition Module for Bridge-Based Sensors

8-Channel USB Multi-Sensor Measurement Module

Dynamic Data Acquisition and Analysis

4-Channel USB Data Acquisition Module for Bridge-Based Sensors

8-Channel USB Multi-Sensor Measurement Module

Dynamic Data Acquisition and Analysis

- 4 DI analog inputs
- 24-bit, up to 52.7 kHz
  per channel
- direct support for full-, half-,
  and quarter-bridge sensors
- programmable excitation
  voltage up to 10V
- powered by USB
- ready-to-run device
- boxed with RJ50 connectors
- up to 8 DI analog inputs
- 24-bit resolution
- 960 Hz sampling rate (sum)
- direct support for bridge-
  based sensors, RTDs, NTCs,
  thermocouples, voltage to
  ±10V, current ±25mA,
  resistance
- powered by USB
- 500 Volt USB port isolation
- built-in screw terminals
- free QuickDAQ application
- Acquire and record up to
  16 channels
- Use DT9838, DT9837, and
  DT9847 series USB DAQ
  modules
- Realtime FFT-Analyzer for
  Modal Analysis
- Single and dual-channel FFT
  functions
- Digital Filters
- Waveform Generator

Show products



Show products



Show products



Print PageBack To TopHelp DeskHome
Data Translation UKPhone: +44-1256 33 33 30Fax: +44-1256 33 33 88Email: Info@DataTranslation.co.uk